August 7, 2013, Germany, New Zealand must Fort - - time, car repair in the repair shop from 2015 onwards will be greatly reduced. Thanks to Audi, Continental, Infineon Technologies and ZMDI for joint research. In the DIANA project, these companies focused their research on improving the analysis and diagnostic capabilities of automotive electronic control units (ECUs). Under the leadership of Infineon, three years of research has created a more differentiated method of fault detection, which has greatly accelerated the speed of repairs in the repair shop. With the support of research institutions and universities, the method already has "end-to-end diagnostic capabilities for semiconductor components and high-level systems used to analyze ongoing and unscheduled automotive failures" (DIANA) Today's automotive electronic equipment is very complicated. Modern cars are equipped with an average of 80 ECUs, and advanced cars may be equipped with 100 or more. Experience has shown that it is impossible to find the exact cause of failures based on the numerous failures reported by automotive electronic systems. The repair shop usually has no choice but to narrow down the fault scope by systematically replacing system components until the fault is finally eliminated. With the help of the methods developed in the DIANA project, in the future, it will be possible to identify automotive electronic faults more quickly, so that they can be repaired more efficiently. The decisive factor for this achievement is the quality control method deployed in semiconductor production. These methods have been further developed by DIANA project partners, so that the chips integrated into the car can be directly used in car self-diagnosis systems. Therefore, the ECU in the car can continuously monitor itself before the car is started and during driving. Based on these continuously collected self-diagnostic data, the fault can be detected early in the fault, because the diagnostic data is transmitted to the high-level system components of the ECU in a preprocessed form. This provides a great help for electromechanical engineers in the repair shop to diagnose the fault. It is the targeted cooperative research and development of DIANA partners that makes such a comprehensive diagnostic capability of automobiles a reality. If the diagnostic technology proves to be reliable and practical in the automotive field, it will also be widely used in other areas where safety is important, such as trains and airplanes and other modes of transportation and medical technology. The DIANA project is sponsored by the German Federal Ministry of Education and Research (BMBF) of approximately 4.8 million euros and is part of the government ’s high-tech strategy and the "2020 Information and Communication Technology Plan" (IKT 2020). Among the many themes of IKT 2020, the core theme is automotive and mobility, aiming to greatly improve the stability of automotive electronic devices. Other project participants The four project partners received help from the Fraunhofer Institute for Integrated Circuits in Dresden, the Bundeswehr University in Munich, the Cottbus University, the University of Erlangen-Nuremberg and the University of Stuttgart. About Audi As a high-end car manufacturer, Audi AG provided 1,455,123 cars to customers worldwide in 2012. The company develops and manufactures in Ingolstadt, Neckarsulm, Germany and 8 other branches abroad. The Audi Group has more than 70,000 employees, acquired Lamborghini and Ducati, and achieved sales of 48.8 billion euros in 2012. About Continental With sales of 32.7 billion euros in 2012, Continental is the world's leading automotive supplier. As a supplier of braking systems, power and chassis systems and components, instrumentation, infotainment solutions, automotive electronics, tires and technical elastomers, Continental has made great contributions to enhancing driving safety and global climate protection. Continental is also a professional partner for networked automotive communications. Continental currently has approximately 173,000 employees in 46 countries. For more information, please visit TInental-corporaTIon.com. About ZMDI Zentrum Mikroelektronik Dresden AG (ZMDI) is a global supplier of analog and mixed-signal semiconductors for automotive, industrial, medical, mobile sensing, information technology, and consumer applications. These solutions enable customers to create the most energy-efficient power management, lighting and sensor products. Over the past 50 years, ZMDI has developed into a multinational company with its headquarters in Dresden, Germany. ZMDI has more than 320 employees worldwide and has sales offices and design centers in Germany, Italy, Bulgaria, France, Ireland, Japan, South Korea, Taiwan and the United States to provide services to customers. About Infineon Infineon Technologies AG, headquartered in Neubiberg, Germany, provides semiconductor and system solutions for the three major scientific and technological challenge areas of modern society—energy efficiency, mobility, and security. In fiscal year 2012 (as of September 30), the company achieved sales of 3.9 billion euros and had approximately 26,700 employees worldwide. Infineon is currently listed on the Frankfurt Stock Exchange (ticker symbol: IFX) and the U.S. over-the-counter market (OTCQX) InternaTIonal Premier (stock code: IFNNY). Infineon in China Infineon Technologies AG officially entered the Chinese market in 1995. Since the establishment of the first company in Wuxi in 1996, Infineon's business has achieved very rapid growth. With more than 1,300 employees in China, it has become an important driving force for the development of Infineon's Asia-Pacific and global businesses. Infineon has established a complete industrial chain covering R & D, production, sales, marketing, technical support, etc. in China, and has carried out in-depth cooperation with domestic leading companies and universities in sales, technical research and development, and personnel training. Cooperation. Safety Light Curtain,Safety Curtain,Laser Safety Light Curtain,Safety Optic Light Curtain,Security Light Curtain,Press Brake Safety Light Curtains Jining KeLi Photoelectronic Industrial Co.,Ltd , https://www.sdkelien.com
The latest research shows that the DIANA research project makes it possible to quickly repair car failures
SDKELI has been manufacturing safety light curtains for more than 20 years. Its brand [SHANGSHOU" and [SDKELI" owns largest market share in China because of reliable quality and proper price. All the safety light curtains are type 4 with CE certificate.